Skip to main content

Monostable Multivibrator (One-Shot)

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

6


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

A short trigger moves a transistor pair into a temporary state; an RC network restores its stable state.

Circuit notes

Monostable Multivibrator (One-Shot)

A short trigger moves a transistor pair into a temporary state; an RC network restores its stable state.

Circuit operation

One feedback path is resistive and the other contains CT. A short trigger reaches Q1 through DS; the diode isolates the timing circuit when the trigger returns low. RT then recharges CT until regenerative switching returns it to the stable state.

Expected behavior

tp∼RTCTt_p\sim R_TC_T tp≈ln⁡2 RTCTt_p\approx\ln2\,R_TC_T

The output pulse is much longer than the 50 µs trigger. CI = 10 nF suppresses rapid collector chatter; brief negative undershoot can remain during switching because of capacitive coupling. Its exact duration depends on the transistor thresholds and capacitor starting voltage. Triggers begin at 8 ms and repeat every 20 ms, leaving recovery time for both the 100 nF baseline and the 200 nF experiment.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 40.0 ms with a maximum step of 5.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set CT to 200 nF; the temporary state lasts longer. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
6 components
NameManufacturerMPNCountType

Resistor

Generic

—

7

Official

Capacitor

Generic

—

2

Official

NPN BJT

Generic

—

2

Official

DC Voltage Source

Generic

—

1

Official

Diode

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.