Skip to main content

TTL NAND

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

5


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

A diode representation of a multi-emitter input and a bipolar phase splitter drive a totem-pole NAND output.

Circuit notes

TTL NAND

A diode representation of a multi-emitter input and a bipolar phase splitter drive a totem-pole NAND output.

Circuit operation

DA and DB represent the input junctions of a multi-emitter transistor. Q1 is the phase splitter; Q2 supplies output current and Q3 sinks it. DO prevents the upper device from holding the output up while the lower device turns on.

Expected behavior

Y=AB‾Y=\overline{A B} VOH≈VDD−VBE−VDV_{OH}\approx V_{DD}-V_{BE}-V_D

The high output is below 5 V because of the emitter-follower and diode drops. The active pull-up is stronger than a resistor-only pull-up. This explanatory equivalent does not model a particular TTL IC or every multi-emitter parasitic.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set V1 period to 3 ms and pulse width to 1.45 ms; compare the truth table at the new input timing. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
5 components
NameManufacturerMPNCountType

Diode

Generic

—

5

Official

Resistor

Generic

—

5

Official

NPN BJT

Generic

—

3

Official

Pulse Voltage Source

Generic

—

2

Official

DC Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.