Skip to main content

TTL NOR

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

5


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Parallel bipolar input stages drive a totem-pole output to realize the NOR function.

Circuit notes

TTL NOR

Parallel bipolar input stages drive a totem-pole output to realize the NOR function.

Circuit operation

Either input transistor can pull the shared phase-splitter collector low and raise the pull-down drive. The upper emitter follower and lower transistor form an active totem-pole output.

Expected behavior

Y=A+B‾Y=\overline{A+B} Y=1only when A=B=0Y=1\quad\text{only when }A=B=0

The output is low when either input is high. As in the NAND equivalent, the high output is below the positive rail. This circuit demonstrates the bipolar NOR switching principle rather than a transistor-for-transistor model of a specific IC.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 4.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set V1 period to 3 ms and pulse width to 1.45 ms; compare the truth table at the new input timing. Restore the saved values after comparing the result.

Model limits

These are generic transistor models, not a specific manufactured part. The bipolar models use nominal forward current gain 100 with illustrative junction capacitances and transit times. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Components used

Components used
5 components
NameManufacturerMPNCountType

Resistor

Generic

—

5

Official

NPN BJT

Generic

—

4

Official

Pulse Voltage Source

Generic

—

2

Official

DC Voltage Source

Generic

—

1

Official

Diode

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.