Skip to main content

555 Internals

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

6


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Expose the resistor divider, two comparators, SR latch, and discharge switch that explain 555 operation.

Circuit notes

555 Internals

Expose the resistor divider, two comparators, SR latch, and discharge switch that explain 555 operation.

Circuit operation

Three equal 5 kΩ resistors generate the one-third and two-thirds supply references. The lower comparator sets the SR latch when CT falls below the lower reference; the upper comparator resets it above the upper reference. Qbar drives a discharge MOSFET, and Q is the output.

Expected behavior

VL=VDD/3VH=2VDD/3\begin{gathered}V_L=V_{DD}/3\\V_H=2V_{DD}/3\end{gathered} f≈1ln⁡2 (RA+2RB)CTf\approx\frac{1}{\ln2\,(R_A+2R_B)C_T}

The timing waveform repeatedly crosses the two flat reference traces. Compare this functional internal circuit with the packaged 555 square-wave example. The op-amp models stand in for comparators; the small latch RC networks give the feedback loop finite settling time. Internal reset and detailed output-driver circuitry are omitted.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 3.0 ms with a maximum step of 0.10 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set CT to 20 nF; compare the slower charge/discharge cycle against the same internal comparator thresholds. Restore the saved values after comparing the result.

Model limits

The packaged timer uses supply-relative comparators and a stateful latch with finite output (100 Ω) and discharge (20 Ω) resistance. It models timer behavior, not IC supply current or thermal limits. Timing estimates ignore those resistances, leakage, comparator delay, and component tolerances. The internals example is a functional explanation rather than a transistor-level IC replica. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Reference: TI 555 timer datasheet.

Components used

Components used
6 components
NameManufacturerMPNCountType

Resistor

Generic

—

8

Official

Capacitor

Generic

—

3

Official

NOR 2-Input

Generic

—

2

Official

DC Voltage Source

Generic

—

1

Official

N-channel MOSFET

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.