Skip to main content

Blocking Inductive Kickback

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

7


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

Provide a flyback path for coil current with a diode and compare the limited switch voltage with the slower current decay.

Circuit notes

Blocking Inductive Kickback

Provide a flyback path for coil current with a diode and compare the limited switch voltage with the slower current decay.

The 12 V supply feeds R1 = 100 Ω and L1 = 100 mH. SW1 starts closed and opens at 5 ms. D1’s cathode faces the supply and its anode faces the switch node, so the diode is reverse-biased during normal energization and conducts during flyback.

I0≈12100+0.1=119.9 mAI_0\approx\frac{12}{100+0.1}=119.9\,\mathrm{mA} EL=12LI02≈0.719 mJE_L=\frac12 LI_0^2\approx0.719\,\mathrm{mJ} Vswitch≈12 V+VFV_{\mathrm{switch}}\approx12\,\mathrm{V}+V_F

C1 = 100 nF remains across the switch. It can produce a small residual ring after the diode stops conducting. D1 routes the current around the complete resistor-inductor branch. Vswitch rises only to roughly 12.7–12.8 V while Icoil decays continuously. The diode limits voltage by allowing a longer current decay; it does not make the stored energy disappear instantly.

Try it. Set L1’s Inductance to 200 mH. The opening current is unchanged because the simulation begins at the closed-switch DC operating point, but the stored energy doubles and flyback lasts longer. Restore 100 mH. Compare this chart with the separate Inductive Kickback example.

Read the chart. Vswitch is green and Vcontrol red. The blue Icoil trace measures the actual winding branch. The pulse source changes from 5 V to 0 V; the switch’s thresholds are 4 V and 1 V. The view includes the energized state, the 5 ms opening and the decay.

Model limits. Switch off resistance is 100 MΩ. The model omits avalanche, arcing, saturation and device damage. The diode, when present, is a generic junction model; real protection parts need suitable current, energy and reverse-voltage ratings.

Components used

Components used
7 components
NameManufacturerMPNCountType

Capacitor

Generic

—

1

Official

DC Voltage Source

Generic

—

1

Official

Diode

Generic

—

1

Official

Inductor

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Resistor

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.