555 Sawtooth Oscillator
CircuitSim
·
Created Oct 3, 2026
·
Updated Oct 3, 2026
Details
Components
5
Schematic
Yes
Simulation
Transient analysis
Copies
Not copied yet
About this circuit
Charge the timing capacitor with approximately constant current to obtain a nearly linear ramp.
Circuit notes
555 Sawtooth Oscillator
Charge the timing capacitor with approximately constant current to obtain a nearly linear ramp.
Circuit operation
The PNP stage charges CT with approximately constant current. Both threshold and trigger inputs monitor CT. When the upper threshold is reached, the 555 discharge path quickly returns CT to the lower threshold before the next charge ramp begins.
Expected behavior
The 3.5 V base reference and 1 kΩ emitter resistor set roughly 0.7 mA. With CT = 100 nF, the rising interval is about 0.23 ms. The 100 Ω discharge resistor limits reset current and makes the short falling ramp visible. The exact current depends on the transistor base-emitter drop.
Reading the results
The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.
The saved transient runs for 3.0 ms with a maximum step of 0.10 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.
Try a change
Double CT; the oscillation period approximately doubles while the threshold voltages remain unchanged. Restore the saved values after comparing the result.
Model limits
The packaged timer uses supply-relative comparators and a stateful latch with finite output (100 Ω) and discharge (20 Ω) resistance. It models timer behavior, not IC supply current or thermal limits. Timing estimates ignore those resistances, leakage, comparator delay, and component tolerances. The internals example is a functional explanation rather than a transistor-level IC replica. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.
Reference: TI 555 timer datasheet.
Components used
Components used
5 components
Try this circuit yourself
Free to get started. No download — runs in your browser with a full SPICE engine.