Skip to main content

555 Pulse Sequencer

CI

CircuitSim

·

Created Oct 3, 2026

·

Updated Oct 3, 2026

Preview will appear once the owner saves the schematic
Details

Components

6


Schematic

Yes


Simulation

Transient analysis


Copies

Not copied yet

About this circuit

The falling edge of one monostable starts a second monostable, producing two successive pulses.

Circuit notes

555 Pulse Sequencer

The falling edge of one monostable starts a second monostable, producing two successive pulses.

Circuit operation

U1 generates the first monostable pulse. CEDGE couples its falling edge to U2 trigger, while RPULL restores that trigger to VDD. The clamp diode limits the positive step at the beginning of U1 pulse. U2 then produces the second pulse.

Expected behavior

t1≈1.1RTCTt_1\approx1.1R_TC_T t2≈1.1RT2CT2t_2\approx1.1R_{T2}C_{T2}

The first output lasts about 1.1 ms; the second begins when the first ends and lasts about 0.52 ms. Both fit inside the 2 ms input period. A short overlap caused by finite propagation delay is possible at the handoff.

Reading the results

The first voltage probe is green and the second is red. Additional voltage traces use distinct colors. Current probes, when present, start with blue and then purple. The chart opens with separate traces on a fixed time window; the table retains the same probe order. Zoom to extents includes the complete schematic.

The saved transient runs for 6.0 ms with a maximum step of 1.00 µs. Compare settled cycles after startup and use time-axis cursors to measure delays or periods.

Try a change

Set RT2 to 68 kΩ; the second pulse becomes longer while its start still follows the first pulse falling edge. Restore the saved values after comparing the result.

Model limits

The packaged timer uses supply-relative comparators and a stateful latch with finite output (100 Ω) and discharge (20 Ω) resistance. It models timer behavior, not IC supply current or thermal limits. Timing estimates ignore those resistances, leakage, comparator delay, and component tolerances. The internals example is a functional explanation rather than a transistor-level IC replica. Device mismatch, temperature drift, layout parasitics, breakdown and detailed noise are not represented. The schematic and component properties expose the values used.

Reference: TI 555 timer datasheet.

Components used

Components used
6 components
NameManufacturerMPNCountType

Capacitor

Generic

—

7

Official

Resistor

Generic

—

5

Official

555 Timer

Generic

555

2

Official

DC Voltage Source

Generic

—

1

Official

Diode

Generic

—

1

Official

Pulse Voltage Source

Generic

—

1

Official

Try this circuit yourself

Free to get started. No download — runs in your browser with a full SPICE engine.